공지사항

Ghost 2 Immobiliser Problems

Created to guard vehicles from key cloning and hacking The Ghost 2 immobiliser is a discreet device that can be fitted without causing damage to your vehicle. It stops your vehicle from starting until you press the correct sequence of buttons inside your vehicle similar to the password of the phone.

Stop/Start

Ghost Immobilisers prevent vehicles from being stolen by stopping the engine from running unless it receives the correct PIN code. This is accomplished without altering the vehicle, and is largely undetectable by thieves. The unit communicates with the ECU on the CAN data bus, which allows it to lock the vehicle. This system is similar to that used by car manufacturers for a long time. However, thieves are unable to overcome it using a brand new key or key relay technology, like they could with factory-installed systems.

Ghost is compatible with any vehicle with an engine, including cars, vans, motorhomes and caravans, as well as bikes. The same system can also be used on electric cars. It is an excellent alternative to locking the steering wheel and wheel clamps that can be installed with minimal effort.

When the Ghost is activated, it will block all buttons in your car, preventing the ignition from starting without a PIN code. This can be done via the Android or Apple mobile app or by manually entering the code using your key fob. If the wrong code is entered, the app will show an indicator light. The Ghost will then refuse to let the vehicle to start again. This is a great deterrent. in the event that the vehicle cannot be started the thief will move on to another victim.

The Ghost is a small, weatherproof device that is able to be hidden behind the most difficult-to-access areas of your vehicle. Installation takes between 20-30 minutes for each vehicle. It is also very simple to remove if you decide to switch your vehicle or hand it in for service or valet parking. It is a fully TASSA (Tracking and Aftermarket Security Systems Association) insurance approved system that is endorsed by a few insurance companies. It also has an emergency Pin Code override and features the Service/Valet Mode which can be activated using an app button or with your key fob.

Disarm

Ghost immobilisers, unlike mechanical anti-theft devices that are able to be removed, Ghost 2 Immobiliser Problems are concealed within the car. They are virtually impossible to hack or bypass and, even if they are found, a thief is unable to start the engine. This is because a ghost 2 immobiliser installation immobiliser prevents key hacking, signal jamming and device spoofing, all of which are methods that are commonly used by thieves to get into vehicles that have standard immobilisers.

An immobiliser works by sending an electronic code to the ECU (electronic control unit). If the incorrect code is received, the vehicle cannot be started because the engine won't start up. It is possible to disable a ghost immobiliser by using the aid of a software program, however it's extremely time-consuming and difficult to accomplish this. The software must be installed and operated by a authorized installer.

The Ghost immobiliser, a tiny system, is hidden within the wiring loom of your vehicle. It is inaccessible to the naked eye once installed. It is not visible on diagnostic systems, there are no LED indicators, and it does not communicate with the engine via the OBD port. It communicates in a silent manner through the CAN data circuit.

The system will block the vehicle from starting until it receives a user defined PIN code sequence. This can be entered using buttons on the steering wheel, door panels or centre console. This is a safer way to protect your car since it doesn't require keys or remote control.

Ghost also comes with a service mode that can be turned on via the mobile application. This allows you to give your keys to a person for servicing or valet parking without entering the disarm sequence.

It is not recommended to remove the system on your ghost vehicle immobiliser yourself, regardless of whether it's in service mode. This could damage your engine. It is recommended to speak with an installer certified by TASSA who will safely and properly remove the system. Our newest GHOST immobilisers come with a unique fingerprint QR sticker hidden in different parts of your vehicle. These are linked to our security register. In the event that the system is removed and later sold on the blackmarket it will be able to trace the original owner.

Anti-Hijack

Ghost Immobiliser 2 has a very useful anti-hijack feature. This system is a smart key that protects your car from theft. If the ignition switch is switched to on, and the vehicle is stationary for 30 seconds, the Ghost system will automatically stop the engine and turn the hazard lights on. This allows the driver or passenger time to press a secret security button (depending on the vehicle) before the system reactivates and the engine is again allowed to start.

Contrary to many other systems that simply stall the engine once the ignition switch is turned on and on, the Ghost system is based on a specific controller and timer unit that will close the valve that cuts off fuel if it is activated after an agreed-upon time even when the ignition is in operation! The delay time must be sufficient to allow the owner of the vehicle to get away, and a distance sufficient from the stalled car before the system is reactivated.

The Ghost comes with added security to prevent common hacking methods used to gain entry into modern cars, Ghost 2 Immobiliser Problems such as relay attacks and key range extending. This is due to the fact that the Ghost system communicates in a quiet manner and does not emit signals that can be detected by a thief using RF scanning or code grabbing technology.

The Ghost system comes with an option for service or valet mode that allows your vehicle to temporarily be started and driven without the need for PIN code. This is ideal if you are parking your car and need to be away for a short period of time, such as for example, to store groceries in the boot, or open a garage door. The system will end service mode depending on the speed and time or through the simple PIN code entry process that gives you total peace of mind that only you can use your car!

Keyless Entry

With the growing trend in theft of cars using contactless technology, many people are considering additional security options. This is particularly true for those who invested time and money in customizing their car or own expensive cars. An add-on immobiliser can be an affordable method to stop this type of theft as it can prevent your vehicle from starting until the correct pin code is entered on your key fob.

Immobilisers are designed how to fit a ghost immobiliser intercept the various circuits in a vehicle such as those that control the starter motor and the fuel pump. They can also turn off the car alarm to draw attention and deter potential thieves.

These devices communicate with the engine control unit (ECU) via the CAN data circuit and they stop a burglar trying to bypass it by installing a new ECU or using an engine key programmer. These immobilisers are installed discretely and do not leave any marks on your vehicle. They are also unnoticeable with the latest tools of thieves.

In contrast to other systems that require a separate application, or a tag that is worn on the person carrying it and a ghost immobiliser and tracker immobiliser can only be deactivated by pressing a sequence of electronic buttons that are already present on your steering wheel, door panel and centre console, allowing you to choose a custom pin sequence. The pin can be changed as frequently as you'd like, meaning it is as secure as a credit card. It can be even more difficult to crack due to the fact that it requires at least 20 presses.

Ghost also has the Valet/Service mode, which allows you to disable the system if your car will be handed over for valet parking or for service and allows it to operate within set parameters such as 30mph speed limits, so you don't have to worry about your car being driven at a reckless speed. It is then reactivated with the original key or the corresponding entry code.

Installed by our accredited installers and certified installers, it is the most secure and efficient aftermarket CAN-immobiliser available. It is also certified by Thatcham for insurance purposes. The Ghost 2 immobiliser comes with six QR fingerprint labels, as well as an ISR contact card that contains your unique QR codes, and an emergency code that is secure. All of these are kept in your purse or wallet.