공지사항

Peugeot 308 Key Fob replacement key for peugeot partner van

Peugeot's 308 might be somewhat old-fashioned, but it is still appealing. It's not the most luxurious car in its class, but it is an enjoyable and comfortable drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is ongoing or continuous the following suggestions should help.

Water Damage

If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking, canoeing, rafting or [Redirect-301] canyoning it is likely to be damaged by water. Keep your key fob in a dry container whenever you are outside or perform activities that could expose it to excessive amounts water.

You'll also need to ensure that the fob is dry prior to opening it and re-using it. If you notice any smells emanating from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it's been submerged.

A wet circuit board can cause the battery to discharge its charge, or even explode. If you are able to get your keyfob 308 from the water you need to turn the button side up and shake as much water as possible before opening the casing. Take the battery out, and then clean the circuit board using a cotton swab which has been dipped into 90-percent alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could be unable to function could be due to an empty coin battery problems with the receiver module, signal interference, or an electronic chip that is defective. If none of these is the cause, you can try resetting the system by disconnection of the battery at 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start feature that allows the driver to start the car from afar by warming up or cooling down the vehicle prior to getting in. This feature is extremely useful, especially during winter's cold and chilly months. However, it is possible that the remote start system ceases operating due to a range of reasons, such as a dead coin battery.

A coin-shaped battery that is located inside the key fob will last a time of between two and four years, based on how often it's used and where it's purchased. The date of use is usually found on the packaging or listed in the instruction manual.

If the key fob stops working after exposure to water that is clean it is recommended to remove the battery, then clean the electronic chip with a paper towel and isopropyl Alcohol, then dry it thoroughly before replacing it. If you expose it to soapy or salty water, the chip may be damaged and you'll need to replace the key fob entirely.

If you're not certain the battery is in good condition You can test the voltage with a multimeter that is set to the car's voltage range. Connect it to the minus and plus terminals. The voltage should range from 12 to 13 volts, but if it is lower, the battery should be replaced. You can also try to reset the on-board computer by disconnecting the battery at 12 volts for a short period of time, and reconnecting it in reverse order (positive cable first followed by negative). The engine should then start.

Faulty Receiver Module

If you don't see "Key Detected" you might find the receiver module defective. It is the part which sends out an alert when the key fob activates. It also acts as an alarm and blocks the car from starting if it doesn't have the correct key.

It could be due to many reasons, such as water damage or simply getting old. If your Peugeot 308 key fob has been exposed dirty tap water, for instance the electronic chip located inside may be damaged. In this case you will have to take it off and clean it thoroughly using isopropyl or an electronic cleaner. Once it's dry you can put the battery back into the battery and try again.

If the problem persists then it's a good option to consult a local Peugeot specialist or locksmith. They'll be able use a diagnostic tool to help pinpoint the issue and repair it for you.

It is stressful to lose your Peugeot car key. However, a trained auto locksmith can resolve the issue in just a few minutes. They can program your vehicle and cut a new, functioning key for you. Click here to find a locksmith near you.

Faulty Electronic Chip

The chip in the Peugeot 308 key fob plays a vital part in the remote control system. If it becomes damaged, your car might not start or receive a message that reads "anti-theft active". In this situation the only option is to replace the key. Fortunately, professional auto locksmiths can complete the task in the shortest amount of time.

The chip inside the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, clean it right away. You can make use of a towel and isopropyl alcohol to wipe the electronic component. The battery should then be allowed to fully dry.

Sometimes the key fob may not function due to radio interference. This can happen when other devices operate on the same frequency as your Peugeot keyfob. It could be caused by unsafe conditions or objects that are close to the vehicle. It is recommended to visit a peugeot replacement key fob dealer in the event of this problem.

The Peugeot 207/308 Key Fob is delicate and needs particular care. It is important not to drop or throw the key fob. If you lose something, try to find it as soon as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative cable first before connecting the positive.